Shed Updates

I finally got around to building my drill holder!  I have been saving this spot on the pegboard ever since I built it, and I finally put it to use.  I also put the second "loft" in, which you can just see in the top right of this picture.  Finally, I built a shelf at the end of the workbench to hold the Greenworks charger, which cannot be hung on the wall.  You can just see that in the bottom right corner.

New French Door

I was finally able to take the time to reverse the swing on the new French doors.  It turned out very well!  The only thing that I need to address now is the astragal, the white strip that goes down between the 2 doors.  This one is not reversable, so Home Depot has ordered me a new one.  This one will work until it arrives, it just will not seal at the top or bottom of the doors.  
 

We now have blinds on every window in the house, blackout in the bedrooms and light filtering in the rest of the house!

We bought these blinds before the tree fell, but we never got time to install them.  Now that the trim is hung, it was finally time to get the blinds up.  We made our bedroom window much bigger, so we did have to replace those blinds, but the rest fit.  
 

New French Door

This is door number 4 in the back of the house, and I really hope it is the last.  We started off with the 6-foot slider that was there when we bought the house.  We shrunk it down to a 5-foot slider so we had room for switches and lights on the back of the house.  Then we decided to put in a French door instead.  Now, this one has blinds in the glass.  The problem is the swing is the wrong direction!

Dock Anchors

We've had a problem with the dock moving in the spring, after the ice melts but before we get it hooked up to shore.  Last year, it moved far enough to wind up on the neighbor's beach and the 2 pieces got ripped apart!  These 8 new anchors total about 1800lbs, which is what we have in the water right now. The new stainless chain will be here soon, so we should get these in the water this weekend.

Shed Loft

OK, so it's not as much a loft as a shelf.  As small as this shed is, it will be really nice to have additional places to put stuff.  I put a set of mounts on the other end of the shed so I can put another "loft" on the other side as well.  I just need to get the shelf board and cut it to length.

Tree Trimming

We had the pine tree on the lake side and the locust on the left trimmed yesterday.  The branches were starting to touch the roof, so we decided to have them cleaned up a bit.  We took the bottom 2 rows of branches off the pine which opened up the view from the bedroom window.  We also had a bunch of dead wood cut out of the locust. 

Barstools

Our new barstools showed up last week.  We were not able to spend any time at the cabin this weekend, but I needed to run up there to cut some starter strips for the siding at the house on the table saw.  While I was up there, I put the stools together and got a few things cleaned up.  It will be so nice to have these so folks can sit at the bar while we are in the kitchen.

More Trim!

We got more trim work done at the cabin this past weekend.  The top boards on all the windows and doors are now hung, nail holes filled, sanded and primed.  All we need to do now is caulk and paint everything.  Since this board is 5/4 MDF, my nail gun would not set the nails fully.  After fighting with it for a while, I went a picked up a new gun and knocked it out pretty quick after that.

The only door that is not finished is the one leading out to the back deck.  As I said in my last post, we are going to replace it.  In fact, the new door will be here this week!  We ordered it early last week and they have a 5-7 day turn around right now.  With any luck, we will get the new one installed and trimmed out this coming weekend.

Trim!

I spent the weekend working on the trim inside at the cabin.  I have all the windows wrapped except for the top board.  I need to stop at the lumber yard and get some 5/4 x 4s to make those.  I also have the doors and closets wrapped, again short of the top board.  The only door not wrapped is the one leading out to the deck because it is going to be replaced with one that has blinds between the glass.

The framing on wall facing the lake in the master is some of the worst I have ever seen.  The header above the window is off over 1-inch from one side to the other.  You can see the spacer I had to make just to get the trim to fit!  The wall also has a bow toward the lake, so the sill is touching the vinyl cladding on the ends and there is a nearly 1/4" gap in the middle, despite my best efforts to force it into place.